How do I install my new Peli Lid Organiser?

 Lid Organisers are the perfect way to utilise the unused space in the lid of a case. Check out the video below, or keep reading to find out how to fit your new Lid Organiser into your Peli Protector or Peli Storm case.

Peli Protector Cases

In most Protector cases, lid organisers are attached by screwing them into the pre-moulded bosses. However, some older Protector cases and all Storm cases are attached using adhesive backing. If you have an older Protector that uses adhesive backing, please follow the Peli Storm case instructions.

Start the installation by aligning the holes in the lid organiser with the pre-moulded raised bosses in the case lid.

Use a Phillips head screwdriver to carefully screw it into place.

If your case doesn’t have raised bosses, do not attempt to screw your lid organiser in as this will void your warranty.

Peli Storm Cases

If using Velcro adhesive backing, for best attachment first clean the stacking ribs on the inside of the lid and allow to dry. Remove the release film from the Velcro hook material and carefully stick each strip onto the stacking ribs.

Your case is complete! (We recommend waiting 24 hours before using the lid organiser so that the adhesive will take full bond strength to the inside of the lid.)

Leave a comment

Please note, comments must be approved before they are published

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.